A weblog focused on interesting circuits, ideas, schematics and other information about microelectronics and microcontrollers.
E-books
Disclaimer
Because I have not tested all electronic circuits mentioned on this pages, I cannot attest to their accuracy; therefore, I do not provide a warranty of any kind and cannot be held responsible in any manner.
Control stepping motor via USB interface PIF18F4550
13. December 2008 - 3:03 — admin
This is an example that demonstration how to control stepper motor via USB interface.
Feature :- CPU PIC18F4550 with full speed USB interface at 48MHz.- USB 2.0 compliance- Use on-chip USB driver- Control 1 stepping motor.- MPLAB C18 for firmware at USB devices side.- Delphi 6 for PC Host software.Control stepping motor via USB interface PIF18F4550.
